Sprayer Depot Blog

Shurflo Pressure Switch Repair - 8000 Series         
This repair uses the Shurflo Switch Assembly #9437506

Follow these 5 easy steps to repair a Shurflo Pressure Switch on a 8000 series pump:

1. Remove the two power source wires- inspect them to see if one has burned out. ( If so, the kit comes with a replacement wire )
2. Remove the three screws: there's one long and two short screws
3. Remove the pressure switch
4. Take out the diaphragm insert. There will be three pieces.  Reinsert the spring holder and the spring. Next, insert the new seat from the repair kit ~ Make sure it sits flush.  You can also insert the teflon seat, which is optional
5. Replace the trigger switch and tighten all three screws.  Finally, hook the power souce back up

This Kings Sprayer ( model # Kt200p70) is equipped with5.5 HP GX160 Series Honda engine and Hypro D30GRGI Diaphragm Pump (9.5 gpm, 580 psi). Follow these step-by-step instructions to operate this Kings 200 Gallon Highway Ready 2-Wheel Sprayer.

Is your sprayer ready to rock-and roll?  Now's the time to make sure all your spray equipement is in top condition.  Precision is key, especially when considering that many of today's pesticides, herbicides and fungicides are more concentrated formulas than in the past, therefore requiring precise application. Do these 5 things to ensure your sprayer is in tip-top condition: